Live Load vs Dead Load vs Snow Load in Steel Buildings
Every steel building carries three kinds of weight at once, and they are not interchangeable. Dead load is the permanent self-weight of…
Read more →
Category
News
112 articles
Steel Structure Load Calculation, From Loads to Code Checks
A steel structure load calculation adds up every force a building has to carry: its own weight, the people and equipment inside…
Read more →
Metal Siding Cost: $4–$16 per Square Foot Installed
Metal siding runs about $4 to $16 per square foot installed — the panels plus the labor to hang them. The low…
Read more →
Cost to Build a Strip Mall From Shell to Turnkey
Building a strip mall runs about $200 to $400 per square foot turnkey in most U.S. markets, which puts a typical 10,000-square-foot…
Read more →
Two Story Metal Building: Planning a Stronger Second Floor
A two story metal building works like a single-story one at the roof and walls, but everything shifts once you put a…
Read more →
Steel Building Roof Pitch by Panel and Climate
Most steel buildings ship with a roof pitch between 1:12 and 4:12, and a 1:12 low slope is the common factory default.…
Read more →
Steel Building Overhang Sizes and Where to Use Them
A steel building overhang is the section of roof that projects past the wall line, and how far it can reach depends…
Read more →
Metal Building Renovation Without Replacing the Steel Frame
A sound steel frame is almost always the part of an existing metal building you keep, not the part you replace. Most…
Read more →
Steel vs Wood Frame Building When Span Matters
Steel frame and wood frame buildings can carry the same loads and pass the same codes, yet they pull ahead in different…
Read more →
Building Industrial Buildings from Site to Steel Frame
Building an industrial building is less one project than a stack of decisions that lean on each other, from the first soil…
Read more →